Gents, its been a while but i'm back,
so here's my story,
I have many milling programes for my fanuc control leadwell machine posted out with the generic solid cam post. all we have to do it add in the tool calls for the changer and it works fine,
I have a Hass tm1 newly acquired, and have tried to run one of the fanuc programs, however the hass appears to not like the fouth digit after the decimal place that the post produces,
the program will run a few lines at the start but stop at the first line with a digit at 4 decimal places, if we remove the fourth place on a few line s it will read them but still stop at the next line with the fourth place digit,
it looks like we only have to remove all the 4th digits to get the programs to run, but how can we do it as its no possible to just edit them out of the finished program as there is too many line to work through,
Is there somewhere in solid cam that this can be configured to not show offending digit, or can I do something to the control to make it reads it and run,
if neither of these options are available how do I get hold of a post to use with soildwords to run on Hass . where would I buy a post form a reputable scource and how much would I have to pay ?
many thanks men an women if any
carl
I don't have much understanding of software so please keep it simple if possible,