This is with SC8, but I've seen this on 7 as well. I'm hoping someone else can point out something I'm missing here or some slick way around this.
It seems that when lead-in / lead-out are turned on, SprutCAM sometimes only generates code for the leads, and not the remainder of the curve!
Example: This is a fixture plate. You can see from the screen shots that without leads, it generates good paths, but with leads they are wrong. I attached the project for what it's worth. [Or I would if the forum would actually let me post it without throwing an error ... :-( ]
Any input appreciated.
David
It seems that when lead-in / lead-out are turned on, SprutCAM sometimes only generates code for the leads, and not the remainder of the curve!
Example: This is a fixture plate. You can see from the screen shots that without leads, it generates good paths, but with leads they are wrong. I attached the project for what it's worth. [Or I would if the forum would actually let me post it without throwing an error ... :-( ]
Any input appreciated.
David