dnc drip mode for a kitamura 3x w/yasnac I80m
Hi i got a 1994 kitamura mycenter 3x w/ yasnac I80 mb capable of handle up to 3300 lines of code , and I'm wondering if there is a way to set up the dnc drip mode operation were a large program can be...
View ArticleNewbie Can't enter #s 1-20 in diagnostic d0499-d0520
Just wiped out my memory and parameters. I have...
View ArticleNeed Help! Anyone out there using BobCad with a Bridgeport EzTrak?
Loaded the part I built in BobCad into the o....
View ArticleNorthen Ca - Cannot seem to find a used benchtop lathe
Figure I would pass along my observation and see...
View ArticleNeed Help! Morbidelli Author 503 - PGM files using WINXISO
Hi everyone, can someone tell me if a...
View ArticleTTS modular insert tooling-worth the $?
I've been looking at tooling to go with a new...
View Articlex700 double images on anything I etch. Anyone else seen this.
Hi. I'm getting a double image. I just got my...
View ArticleUSB smooth stepper run out of data when ESC is pressed in Mach3, spindle on...
I just purchased a machine with a USS. I was...
View ArticleNewbie Laser Position?
Total newbie here planning on building a laser cutting machine. I hope someone could answer a couple of dumb questions. I noticed that most commercial machines the laser is under the table, and the...
View ArticleAnother question
Hey guys, what would be more favourable? Power from the motor or a more rigid accurate machine? Any comments would be great Many thanks
View ArticleMach3 error
Hi i buy mach3,i try to install it, but i get this, 2013-06-14_1456 - OlaviJing's library Kai
View ArticleNew Machine Build manual surface/cup/wheel grinder with LM Guides on all...
Hello guys, I am running a small production shop here and we need to machine about 2-9 inch long parts within +-0.001 inch (we have to grind slots as well). We have manual wheel and cup grinders having...
View Article