Hello!
At the moment, I am working on designing a little table-size CNC to mill me some PCB's. I think I've already got the HW-part sorted out, so I figured it as time to think about the electronics.
My initial goal was to get one of these, but then I stumbled upon this controller.
I think it looks very promising (because it uses USB, only thing I don't like is that it isn't compatible with MACH3, etc. but the included software seems to be good enough), but I can't find any reviews about it.
Has anyone else used/bought/fried/reviewed/... one of these? I would like to get some feedback from you!
Knutselman
At the moment, I am working on designing a little table-size CNC to mill me some PCB's. I think I've already got the HW-part sorted out, so I figured it as time to think about the electronics.
My initial goal was to get one of these, but then I stumbled upon this controller.
I think it looks very promising (because it uses USB, only thing I don't like is that it isn't compatible with MACH3, etc. but the included software seems to be good enough), but I can't find any reviews about it.
Has anyone else used/bought/fried/reviewed/... one of these? I would like to get some feedback from you!
Knutselman