I create CAD in BobCAD and generate the g-code. Mach 3 and Gecko 540 run the mill. It has worked fine for me. Performance has been good. Today I had an issue where the Z didn't move down for one chain. The X/Y moved properly and the next chain to cut went good.
Lines 470 - 481 are chain that cut good. The command line 483 is ignored. Code was generated by BCC. All cutting in lines before 470 and lines after the 483 string cut good. I don't see an extra character, letter O instead of zero 0. Syntax compared to line 472 seems the same to me. Anyone see something?
N470G00Z0.125
N471X9.6057Y3.5474
N472G01Z0.0156 F25.
N473X9.5777Y3.5753 F40.
N474X9.5663
N475X9.5383Y3.5474
N476Y3.4283
N477X9.5663Y3.4006
N478X9.5777
N479X9.6057Y3.4283
N480Y3.5474
N481G00Z0.125
N482X8.9293Y2.7196
N483G01Z0.0625 F25.
N484X8.5535Y2.7394 F40.
N485G03X8.2719Y2.5896I-0.0163J-0.3089
N486G01X8.1903Y2.4536
N487X7.7469Y2.0989
This is an engraving job.
Lines 470 - 481 are chain that cut good. The command line 483 is ignored. Code was generated by BCC. All cutting in lines before 470 and lines after the 483 string cut good. I don't see an extra character, letter O instead of zero 0. Syntax compared to line 472 seems the same to me. Anyone see something?
N470G00Z0.125
N471X9.6057Y3.5474
N472G01Z0.0156 F25.
N473X9.5777Y3.5753 F40.
N474X9.5663
N475X9.5383Y3.5474
N476Y3.4283
N477X9.5663Y3.4006
N478X9.5777
N479X9.6057Y3.4283
N480Y3.5474
N481G00Z0.125
N482X8.9293Y2.7196
N483G01Z0.0625 F25.
N484X8.5535Y2.7394 F40.
N485G03X8.2719Y2.5896I-0.0163J-0.3089
N486G01X8.1903Y2.4536
N487X7.7469Y2.0989
This is an engraving job.