so i was gone a week and come home and Z will not move .. (x and y work fine )
its on a accumax if i remember correctly .. mill m11 control
tried MPG and jog buttons ..
cant do from a program because not homed ..
have tried OT release , and pushed all other buttons a few times to make sure none are sticking ...
head is about halfway done the mill ..
made sure all limit switches were not stuck ...
i swapped the top servo amp board with another and no difference .
both leds on the drive are green ..
idk if it is supposed to say anything but main mother board says 1 on the display .
tested all fuses ..
the servo is getting power , IE it has holding torque
checked the brushes , looks to be 3/4 long or more .
going to take apart all connectors and spray them with cleaner tomorrow ..
what else could it be ?
its on a accumax if i remember correctly .. mill m11 control
tried MPG and jog buttons ..
cant do from a program because not homed ..
have tried OT release , and pushed all other buttons a few times to make sure none are sticking ...
head is about halfway done the mill ..
made sure all limit switches were not stuck ...
i swapped the top servo amp board with another and no difference .
both leds on the drive are green ..
idk if it is supposed to say anything but main mother board says 1 on the display .
tested all fuses ..
the servo is getting power , IE it has holding torque
checked the brushes , looks to be 3/4 long or more .
going to take apart all connectors and spray them with cleaner tomorrow ..
what else could it be ?