We've got an Okuma Howa Act3 with a 10T control here at work that hasn't been run in a couple years. Had to replace the mainboard, and seeing as I didn't have a copy of the parameters I had the repair man load the parameters from another Act3 he's worked on.
Everything is pretty close except for a few issues. The two I'm working on right now is canceling the tool offset with a T0 in the ref. return line "G0G28U0W0T0" and the tool offsets not clearing out of the absolute position screen. I have tried working the 6000, 6001, 6002 parameters to fix the T0 problem, but nothing changes. It always over travels when it reads that line.
I don't know where to start on my 2nd problem. When the machine goes home with the above line (without the T0) and then cancels the tool offsets using the tool number followed by 2 zero's the absolute screen still shows the tool geometry values. I'm pretty positive the absolute always went to zero when tool offset was canceled.
Any help would be appreciated.
Everything is pretty close except for a few issues. The two I'm working on right now is canceling the tool offset with a T0 in the ref. return line "G0G28U0W0T0" and the tool offsets not clearing out of the absolute position screen. I have tried working the 6000, 6001, 6002 parameters to fix the T0 problem, but nothing changes. It always over travels when it reads that line.
I don't know where to start on my 2nd problem. When the machine goes home with the above line (without the T0) and then cancels the tool offsets using the tool number followed by 2 zero's the absolute screen still shows the tool geometry values. I'm pretty positive the absolute always went to zero when tool offset was canceled.
Any help would be appreciated.