Someone has the control ladder fanuc 0-mb
the problem I have is as follows:
None of the axes move after starting the control and activate the servo drives, try movements in all modes but can not move the axes, when I try to do the movements are active in DGN 0700 # 5 which disables CITL movements axes
any suggestions will help
Nazario
the problem I have is as follows:
None of the axes move after starting the control and activate the servo drives, try movements in all modes but can not move the axes, when I try to do the movements are active in DGN 0700 # 5 which disables CITL movements axes
any suggestions will help
Nazario