Hello
I have an SX3 converted with x4 electronics working in manual mode but am trying to figure out wiring to work with A Gecko g540 for the spindle control.
On the spindle board it has 7 pins which are +12v, +5v, none, none, F/R, PWM, GND. How can I make this work with g540.
Any suggestions would be great.
I have an SX3 converted with x4 electronics working in manual mode but am trying to figure out wiring to work with A Gecko g540 for the spindle control.
On the spindle board it has 7 pins which are +12v, +5v, none, none, F/R, PWM, GND. How can I make this work with g540.
Any suggestions would be great.