setting rapids between cuts ??

Hi...

I'll try to explain as best I can...
Would like to be advise on how to setup so I can "dial" rapids between passes out of the same contour tool path ?
Say you plot you toolpath on a contour and the tool need to retract to go back to stating point to then, cut one more pass for whatever reason you dialed in for !
Where my question is focued on between cut as the tool goes back, how can i get it to parids while moving to the start lead-in point ?
Now, I'm getting same move speed as my feed rate / cutting speed !

Hopping I'm "clear"....?
thks in advance for your time to reply !?!
Later, Robert