I've been working on MasterCAM and with a haas for a few years but I'd still call myself a rookie due to the amount of time I actually use them. Basically this is my problem. Using x7 dynamic paths. When the tool is down to depth I'm asking it to cut at 300ipm. Yet it's not. It's going more like 40-50. When the tool does a micro lift between cuts it's set at 100ipm(which needs to be increased) and the machine actually moves at the speed in which the program says. Only when the tool is engaged in a cut at the programmed 300ipm does it not actually cut at that speed. G61 (exact stop) is off. That was one suggestion I was told to look at. It's a HAAS vf3. Any ideas?
↧