Hi cnczone.com! I am building a desktop CNC machine, and I have ordered my parts. Would you kind folks take a look and see if I am missing anything?
For the machine itself I bought the Shapeoko mechanical kit, which comes with everything except the electronics and the bits.
For the power supply I purchased this: LINK
For the stepper motors I purchased this: LINK
For the controller/driver board I purchased this: LINK
For my first set of bits I purchased 2 and 4 flute 1/8" carbide bits
What am I missing?
On another note, one thing I just realized, in a lot of the Googling I have done I don't actually see a power switch wired in. Is this just a plug and unplug sort of thing?
For the machine itself I bought the Shapeoko mechanical kit, which comes with everything except the electronics and the bits.
For the power supply I purchased this: LINK
For the stepper motors I purchased this: LINK
For the controller/driver board I purchased this: LINK
For my first set of bits I purchased 2 and 4 flute 1/8" carbide bits
What am I missing?
On another note, one thing I just realized, in a lot of the Googling I have done I don't actually see a power switch wired in. Is this just a plug and unplug sort of thing?