Hello. Everyone.
General question or two on Water jet cutting:
1) if a 0.100 inch thick sheet of clear, transparent, polycarbonate (PC) was cut with a "hole" in the top surface, would there be any evidence of abrasion, along the cutting edge of the plastic from the water jet system? Note, that the quality of the cut is extremely important (zero, or very low defects).
2) in respect cut quality, how does water jet cutting compare to CNC cutting (of the hole) through the same material?
If I could please get a response by Tuesday or Wednesday (8/13/13), I'd greatly appreciate it.
Many thanks.
General question or two on Water jet cutting:
1) if a 0.100 inch thick sheet of clear, transparent, polycarbonate (PC) was cut with a "hole" in the top surface, would there be any evidence of abrasion, along the cutting edge of the plastic from the water jet system? Note, that the quality of the cut is extremely important (zero, or very low defects).
2) in respect cut quality, how does water jet cutting compare to CNC cutting (of the hole) through the same material?
If I could please get a response by Tuesday or Wednesday (8/13/13), I'd greatly appreciate it.
Many thanks.