I started my lathe up this morning and was about to continue on with a job I started yesterday. The lathe started up as usual and I pushed the cycle start button. It started the program and did a tool change and then this alarm came up. Alarm A 241 Panel/crp receive 80. I tried to shut down the lathe and fire it back up again hoping it would go away. Now when I power up the lathe it goes thru the boot up menu and when it starts its normal operation mode the screen displays the alarm very briefly and then goes blank. If anyone has any ideas where I could start to look to fix this problem it would be much appreciated. I have not had to call a tech in to fix a machine in my 7 years in business and hope to get this sorted out on my own.
Cheers,
Duane
Lb 15 seral#A216
Cheers,
Duane
Lb 15 seral#A216