Hi!
We bought our Haas VM-2 3 months ago. We are using Edgecam.
Now when I was making a profiling in edgcam on a cone (height 125mm, tollerance 0.01 and cusp height 0.01) the machine doesn't cut the cone in a smooth way. The machine appear like: Goes two rounds and then stop for "0.3s" and then a quater round stop for "0.3s) and then one round stop for "0.3s" etc. etc...
I have been talking to the reseller of the machine, and they do not have an answer to my problem, but they do say that the NCcode is correct as far as they know.
Sorry for my bad english (from Sweden), I hope that I have explaind enough .
Pleas help me!
Best regards: Patrik
IMG_0470[1].jpg
We bought our Haas VM-2 3 months ago. We are using Edgecam.
Now when I was making a profiling in edgcam on a cone (height 125mm, tollerance 0.01 and cusp height 0.01) the machine doesn't cut the cone in a smooth way. The machine appear like: Goes two rounds and then stop for "0.3s" and then a quater round stop for "0.3s) and then one round stop for "0.3s" etc. etc...
I have been talking to the reseller of the machine, and they do not have an answer to my problem, but they do say that the NCcode is correct as far as they know.
Sorry for my bad english (from Sweden), I hope that I have explaind enough .
Pleas help me!
Best regards: Patrik
IMG_0470[1].jpg