Hi Everyone,
I just joined CNCzone and thought a quick introduction would be appropriate. I have owned a job shop here in Jersey for about 33 years! I currently do all the programing ( Gibbs software ) and still do some machine set-up. Along with quoting, engineering, and the other #^%@& paper work that goes along with that. We currently do all cnc milling using 4 mori's and 1 fadal. I have checked out this site before and came away with some good tips. Anyway, any more then that and everybody will be leaving there computers to watch Shark Tank. Actually, I'm programing a Kovar part right now, if anybody has any milling tips it would be helpful. Holes range from .042 to .110 dia x .3 deep, part is .5x1.0x1.5 with a pocket .307 dp with .062 corner rad.
Thanks, Gary
I just joined CNCzone and thought a quick introduction would be appropriate. I have owned a job shop here in Jersey for about 33 years! I currently do all the programing ( Gibbs software ) and still do some machine set-up. Along with quoting, engineering, and the other #^%@& paper work that goes along with that. We currently do all cnc milling using 4 mori's and 1 fadal. I have checked out this site before and came away with some good tips. Anyway, any more then that and everybody will be leaving there computers to watch Shark Tank. Actually, I'm programing a Kovar part right now, if anybody has any milling tips it would be helpful. Holes range from .042 to .110 dia x .3 deep, part is .5x1.0x1.5 with a pocket .307 dp with .062 corner rad.
Thanks, Gary