Here we go again...
A long story condensed, Orienting a part to be drilled. The attached clip shows how my part would be sitting in the mill. The holes show to be going where they should, however when we post the holes come out X positive and drills the hole on the wrong end. Could just rotate the part but we want to know how to do this like it's intended. side note: this software has just about pushed my last button. really trying to make it work.
A long story condensed, Orienting a part to be drilled. The attached clip shows how my part would be sitting in the mill. The holes show to be going where they should, however when we post the holes come out X positive and drills the hole on the wrong end. Could just rotate the part but we want to know how to do this like it's intended. side note: this software has just about pushed my last button. really trying to make it work.