Emco 50 Lathe & Mill Manuals

Hi,
I'm new to this forum, hoping to get some advice on my Emco 50 Lathe and Mill. It came with 1 control, GE Fanuc.

This is a rather long story, I will try to shorten it the best I can.
I was just given these two cnc's, they came from a school, went to another school where they were never used. They were given to me because they new I would fix them up and use them. My intent is to:
#1 get them up and running
#2 possibly start a class at my son's H.S.

I'm about done cleaning them up and ready to turn them on but I have no manuals for either machine. Emco was contacted but has not returned e-mails, so I'm turning to you for advice before I start either one.

Thanks