I have a new Shopmaster Patriot. i can manually control it. I have the computer connected and via Mach3 I can control all the stepper motors. However, I can't get the spindles to turn on.
I followed the wiring directions in the Patriot manual to wire up the nowforever. Mach3 thinks it turns the spindles on when I give a command (e.g. M3 S200) and thinks it stops (M5).
Anyone experienced similar issues when first setting this up?
I followed the wiring directions in the Patriot manual to wire up the nowforever. Mach3 thinks it turns the spindles on when I give a command (e.g. M3 S200) and thinks it stops (M5).
Anyone experienced similar issues when first setting this up?