Hello All,
I have had this machine for about 2.5 years and finally found someone to teach me how to use it properly.
I was trying to machine a part the other day and had to restart. Reset my Z to an area that had already been machined, my mistake!! When it moved to a part that hadn't been machined it tried to plunge too far and stopped the spindle. I hit the e-stop right away and reset everything to run again. When I started the program from the beginning the machine went to where it was supposed to start, but the spindle stayed idle.
I am hoping there is a reset switch or something that can fix this and that I haven't blown a board!!
I have had this machine for about 2.5 years and finally found someone to teach me how to use it properly.
I was trying to machine a part the other day and had to restart. Reset my Z to an area that had already been machined, my mistake!! When it moved to a part that hadn't been machined it tried to plunge too far and stopped the spindle. I hit the e-stop right away and reset everything to run again. When I started the program from the beginning the machine went to where it was supposed to start, but the spindle stayed idle.
I am hoping there is a reset switch or something that can fix this and that I haven't blown a board!!