Hi guys!
I'm after a some help with camworks 2012. I'm fairly new to the software, and been trying for days to figure out how I can reverse the Z axis.
Basically, I have a design in solidworks that requires the top and the bottom faces to be machined, I have a fixture for the part that allows me to machine the top face, flip it over ready to machine the bottom face (now facing upwards). The problem is I'm having trouble finding how you tell camworks to machine this other surface, every time I do, when I simulate machining the features on the bottom face the tool enters from other side, going through the entire part.
I hope this makes sense, please feel free to ask any questions if I haven't be quite clear enough on what I mean.
Any help would be much appreciated.
Regard
John.
I'm after a some help with camworks 2012. I'm fairly new to the software, and been trying for days to figure out how I can reverse the Z axis.
Basically, I have a design in solidworks that requires the top and the bottom faces to be machined, I have a fixture for the part that allows me to machine the top face, flip it over ready to machine the bottom face (now facing upwards). The problem is I'm having trouble finding how you tell camworks to machine this other surface, every time I do, when I simulate machining the features on the bottom face the tool enters from other side, going through the entire part.
I hope this makes sense, please feel free to ask any questions if I haven't be quite clear enough on what I mean.
Any help would be much appreciated.
Regard
John.