I can't get this to work on a Robodrill w/ 31i control.
If I set it to "Machine Stop" it works fine, but when set to "Feed Down + Tool change", it does nothing.
Just keeps drilling and going on like the monitoring is turned off.
Also, when I let the machine calculate the percentages for initial, warning, and breakage loads, I notice it's much lower than what I actually saw on the spindle load meter while drilling.
Are there parameters that have anything to do with this? I haven't found any yet while searching.
If I set it to "Machine Stop" it works fine, but when set to "Feed Down + Tool change", it does nothing.
Just keeps drilling and going on like the monitoring is turned off.
Also, when I let the machine calculate the percentages for initial, warning, and breakage loads, I notice it's much lower than what I actually saw on the spindle load meter while drilling.
Are there parameters that have anything to do with this? I haven't found any yet while searching.