Guys. I need to work out how to get x5 to output a stop when it changes from say a g54 to a g55 wcs. Bad to worry about if before but I now have a job that requires a chamfer on both side of the stock so I need the mill to stop so I can flip the stock. I am using that same cutter for both ops.
At the moment it outputs the g55 but nothing to stop the spindle and wait for me to reposition the job in the vice.
Any ideas guys
At the moment it outputs the g55 but nothing to stop the spindle and wait for me to reposition the job in the vice.
Any ideas guys