This part was imported from Autodesk Inventor using the import plug-in. So no IGES problems this time. The other half of the mold worked great in SprutCam - just about the easiest file I've prepared yet. But this one...
I have a tool that's the same size, or slightly narrower, than the slot I'm trying to cut (I've tried it both ways). It refuses to cut to the end of the slot, or go down the hole. If I set the tool much narrower (0.06 rather than 3/32), then it does. It seems to be stopping at a point when the height of the cut changes.
But this is not a very complex part! Why is it acting crazy? I've tried lots of operations, and nothing works, and some of them do weird stuff like doing one or two waterline passes around the entire circumference of the part (at least if I try to include both symmetrical flats).
Thanks,
Chris
I have a tool that's the same size, or slightly narrower, than the slot I'm trying to cut (I've tried it both ways). It refuses to cut to the end of the slot, or go down the hole. If I set the tool much narrower (0.06 rather than 3/32), then it does. It seems to be stopping at a point when the height of the cut changes.
But this is not a very complex part! Why is it acting crazy? I've tried lots of operations, and nothing works, and some of them do weird stuff like doing one or two waterline passes around the entire circumference of the part (at least if I try to include both symmetrical flats).
Thanks,
Chris