Dear experts on this Zone.
We have Millstar m/c with Fanuc 18i-MB.
The problem is when we are running part program CNC stops in the middle. And CNC gets hang up. We can not operate any button on CNC . I checked on mother board 3 red led is lights up ( SFAIL,SVALM,SEMG).
But we switch off and on again, it starts working about 10 to 30 minutes before it hangs up.
I need to know the possible causes to hang up in the middle of program. The part program on the machine is absolutely no problem. We did several component with same program.
Your Advice is highly appreciated.
Thanks with Best Regards
Dinesh
We have Millstar m/c with Fanuc 18i-MB.
The problem is when we are running part program CNC stops in the middle. And CNC gets hang up. We can not operate any button on CNC . I checked on mother board 3 red led is lights up ( SFAIL,SVALM,SEMG).
But we switch off and on again, it starts working about 10 to 30 minutes before it hangs up.
I need to know the possible causes to hang up in the middle of program. The part program on the machine is absolutely no problem. We did several component with same program.
Your Advice is highly appreciated.
Thanks with Best Regards
Dinesh