Hi,
I have to make thin brass washers.
ID=9.5 mm, OD=16mm. Thicknes= 0.3 ; 0.5 ; 1 and 2mm
(ID=0.374'', OD=0.629''. Thicknes= 0.0118'' ; 0.0196''; 0.0393'' and 0.078'')
Is there some special trick to create a burr-less part?
What cutting speed and feed do you recommend?
Im using this cut off tool:
Iscar Catalog : PENTA 24N-J - 6003226
IC908
Here is a photo of my washers with burr:
ImageShack® - Online Photo and Video Hosting
I have to make thin brass washers.
ID=9.5 mm, OD=16mm. Thicknes= 0.3 ; 0.5 ; 1 and 2mm
(ID=0.374'', OD=0.629''. Thicknes= 0.0118'' ; 0.0196''; 0.0393'' and 0.078'')
Is there some special trick to create a burr-less part?
What cutting speed and feed do you recommend?
Im using this cut off tool:
Iscar Catalog : PENTA 24N-J - 6003226
IC908
Here is a photo of my washers with burr:
ImageShack® - Online Photo and Video Hosting