Hello.
Just wondering how long it takes you to program the following part.
Assume:
3 axis vertical CNC mill.
Part cut out of CRS Bar 1/2x5"x5 1/8"
Drill and tap all holes
Mill part to length, including radius
Using Narrow/Soft jaws that will allow you to mill both sides of part in one clamping.
Use any method to program the part, by hand, conversional, Cam, Marco, ect.
Attached a PDF of the part and various solid models.
Here is my time:
Haas VQC: 8 min.
Inventorcam2013: 20 min.
Please leave comment on witch method you used.
Just wondering how long it takes you to program the following part.
Assume:
3 axis vertical CNC mill.
Part cut out of CRS Bar 1/2x5"x5 1/8"
Drill and tap all holes
Mill part to length, including radius
Using Narrow/Soft jaws that will allow you to mill both sides of part in one clamping.
Use any method to program the part, by hand, conversional, Cam, Marco, ect.
Attached a PDF of the part and various solid models.
Here is my time:
Haas VQC: 8 min.
Inventorcam2013: 20 min.
Please leave comment on witch method you used.