Hello Men,
So far the PNC 1100 Has been great! I want to wish all of you a blessed holiday season and great Christmas.
Here is my question, I was milling a pretty expensive part and found the need to change the code to correct a problem. I kept the part in the fixture and retained X,Y and Z. I cannot seem to figure out how to start the machine up at a line number in the G code to avoid having to start completely over. The part takes 13 hours to fully cut! I cannot seem to find or figure out how to call the line number for a tool and start cutting again from that point. As always your help is greatly appreciated. I will be posting some cool three D parts once I can get through this road block and not waste the stock.
Kind Regards,
John
USMC Retired
So far the PNC 1100 Has been great! I want to wish all of you a blessed holiday season and great Christmas.
Here is my question, I was milling a pretty expensive part and found the need to change the code to correct a problem. I kept the part in the fixture and retained X,Y and Z. I cannot seem to figure out how to start the machine up at a line number in the G code to avoid having to start completely over. The part takes 13 hours to fully cut! I cannot seem to find or figure out how to call the line number for a tool and start cutting again from that point. As always your help is greatly appreciated. I will be posting some cool three D parts once I can get through this road block and not waste the stock.
Kind Regards,
John
USMC Retired