Akira seiki lathe with fanc O/T having turret problem..im not getting the turret to unclamp or clamp ,no air to unclamp ., no voltage is there to activate.
Tool 1 proxi reads its at tool 1/ im thinking the clamp unclamp proxi has a problem. switched around relays didnt fix ,other wire goes to board with no voltage coming out to activate air but board has power. ohm at solenoid seems good.can manually switch solenoid to clamp/unclamp.. THANK you for any input
Tool 1 proxi reads its at tool 1/ im thinking the clamp unclamp proxi has a problem. switched around relays didnt fix ,other wire goes to board with no voltage coming out to activate air but board has power. ohm at solenoid seems good.can manually switch solenoid to clamp/unclamp.. THANK you for any input