I have the SSR and breakout board pictured. Currently I have it wired as follows.
pin 3+ of SSR to 5v+ on breakout (Verified 5 volts with DVM)
Pin 4- of SSR to to output 1 of Breakout.
Pins 1 and 2 of the SSR I have yet to figure out how they wire to the torch.
When I run Mach 3 on a test bracket I made in Sheetcam, the SSR doesnt do anything. The red light just stays lit all the time. I used Diagnostics in Mach 3 to manually turn on/off spindle controll and no changes. All i get is Mach says output one is active and output one blinks on the screen when I turn it on. I plan to hook this up to a Thermal Dynamics cutmaster 52.
I'm wondering if anyone knows how to wire this up, because I don't think I did it correctly.
pin 3+ of SSR to 5v+ on breakout (Verified 5 volts with DVM)
Pin 4- of SSR to to output 1 of Breakout.
Pins 1 and 2 of the SSR I have yet to figure out how they wire to the torch.
When I run Mach 3 on a test bracket I made in Sheetcam, the SSR doesnt do anything. The red light just stays lit all the time. I used Diagnostics in Mach 3 to manually turn on/off spindle controll and no changes. All i get is Mach says output one is active and output one blinks on the screen when I turn it on. I plan to hook this up to a Thermal Dynamics cutmaster 52.
I'm wondering if anyone knows how to wire this up, because I don't think I did it correctly.