First of all, I'm about 2 weeks into FeatureCAM and, holy crap; this software is awesome! I've used a few other CAD/CAM software's (BobCad, MasterCam, Solid Works) and, FeatureCAM seems to be the easiest/most intuitive of the bunch!
Now to my problem...
I'm working on editing a post but, I can't seem to figure out how to make the first line of the canned cycle rapid down to the X value, then feed to the starting Z value on a lathe.
I'm configuring the post for a Mori Seiki SL-25 lathe with Fanuc-0T controls, (not sure if that's the correct wording but, that's what the boss calls it); I doubt that's pertinent towards this post but, I figure I might as well, doesn't hurt.
Now to my problem...
I'm working on editing a post but, I can't seem to figure out how to make the first line of the canned cycle rapid down to the X value, then feed to the starting Z value on a lathe.
I'm configuring the post for a Mori Seiki SL-25 lathe with Fanuc-0T controls, (not sure if that's the correct wording but, that's what the boss calls it); I doubt that's pertinent towards this post but, I figure I might as well, doesn't hurt.