Hi all,
This is my first post here so I should start by introducing myself. My name is Rob and I work for a manufacturing company in the UK as a CAM engineer. We have a Mazak J200 which is currently being operated by a machinist using the on board mazatrol control. We are looking into posting from the CAM system we use to the Mazak but I've run into a few issues in my own experience with Mazaks.
Would any of you happen to have a post which works with a mazak controller in EIA format that I could take some of the formatting from? (i.e. looking at opening and closing sectors).
Thanks and Regards
Rob.S
This is my first post here so I should start by introducing myself. My name is Rob and I work for a manufacturing company in the UK as a CAM engineer. We have a Mazak J200 which is currently being operated by a machinist using the on board mazatrol control. We are looking into posting from the CAM system we use to the Mazak but I've run into a few issues in my own experience with Mazaks.
Would any of you happen to have a post which works with a mazak controller in EIA format that I could take some of the formatting from? (i.e. looking at opening and closing sectors).
Thanks and Regards
Rob.S