Hi, I've been looking around for a while on the 1100 but due to my basement door being 31" I would have to disassemble it. I've watch the PCNC 1100 on youtube, read about it's ability here and for the most part many are happy.
I am backing down to order a 770 since it's easier to move. I have no back ground and it seems like an exspensive equiment to break.
My question is, how would the 770 handle steel for custom engine mounts? I'va also ready if you are expecting 770 for milling steel, think again.
Thank you.
I am backing down to order a 770 since it's easier to move. I have no back ground and it seems like an exspensive equiment to break.
My question is, how would the 770 handle steel for custom engine mounts? I'va also ready if you are expecting 770 for milling steel, think again.
Thank you.