I'm setting up a new PC and reloaded V23 and got the license transfered. I downloaded the post that I use; (Mach3 w/Z stops) and installed it.
It dosn't work the same way as on my old pc and I was wordering if there is a way to copy the PP from my old PC and install it on my new one.
I also purchsed the v25 upgrade and this PP dosn't work on it either. I created a simple 2" square and created a contour on it. When programming with a .25 lead in and out I get 3" crop circles where the leads should be; the rest of the contour appears to be correct its just the leads that are wrong.
Thanks for any help,
Dave
It dosn't work the same way as on my old pc and I was wordering if there is a way to copy the PP from my old PC and install it on my new one.
I also purchsed the v25 upgrade and this PP dosn't work on it either. I created a simple 2" square and created a contour on it. When programming with a .25 lead in and out I get 3" crop circles where the leads should be; the rest of the contour appears to be correct its just the leads that are wrong.
Thanks for any help,
Dave