Hi, I am in the process of purchasing a vacuum table and pump for my cnc router. My cutting footprint is 900mm x 700mm so the vacuum table will be to this size. 18mm MDF will be used as a spoilboard so i will need the vacuum to be able to suck through spoilboard over the 900 x 700 area.
I was advised by someone that the Becker model VT 4.40 , it has a flow of 28CFM, that will do the job??
It would be nice just to place any jobs i have big or small onto the table and not have to worry about double sided tape, clamps, screws.
Thanks
I was advised by someone that the Becker model VT 4.40 , it has a flow of 28CFM, that will do the job??
It would be nice just to place any jobs i have big or small onto the table and not have to worry about double sided tape, clamps, screws.
Thanks