I have several occasions where I'm milling circles and I'd like to do it in a cork screw / helical plunge type fashion.
Is there a (an easy) way to do this in BobCAD?
Alternatively... From point centers I could do this in Notepad by hand if there's a command for that.
I'd like 1/4" circles using a 3/16" diameter cutter.
Is there a (an easy) way to do this in BobCAD?
Alternatively... From point centers I could do this in Notepad by hand if there's a command for that.
I'd like 1/4" circles using a 3/16" diameter cutter.