Hello
Can someone help me with M-codes for programmable tailstock, i have one in my Okuma LC-20 lathe. I have been using tailstock longtime in manual mode, but i haven't never programmed it. I was searching codes or G-code lines from internet but i didn't found any other proper codes than M55 and M56 which are used to get live center out and in. If someone would have lines of G-code where tailstock in use and/or M-codes it would be really awesome.
Can someone help me with M-codes for programmable tailstock, i have one in my Okuma LC-20 lathe. I have been using tailstock longtime in manual mode, but i haven't never programmed it. I was searching codes or G-code lines from internet but i didn't found any other proper codes than M55 and M56 which are used to get live center out and in. If someone would have lines of G-code where tailstock in use and/or M-codes it would be really awesome.