Hi,
On my router table, I am using DMM system. I am 99% sure issue is with my environment and not DMM but in past I am able to get good information on this thread and hoping that somebody may have seen similar issue reported and can point me in the right direction.
I am attaching the g code file causing the issue. Very simple file created by Aspire. System execute line N26650 and stop at line N26660 (N26660G00X1.2901Y2.2109).
Attachment 171562
I tried five time and system always stop at this point. I started at different starting points on the table, did ref all and check dro and machine coordinates and my soft limits, nothing seems to be out of order. I do have licensed copy of Mach3 and also checked the line count to make sure that I am not stopping at eval line limit on mach3. Once I get stuck on G code, I am not able to physically jog, DRO do change but I am not able to move the spindle from stuck position. Only way to get out of this situation is to power cycle DMM drivers. And one thing more, although I was away from router table for few weeks to setup the mill, but I am able to make few carving gifts for friends last week .... so machine is in good working condition.
Once system do get stuck and I power cycle DMM drivers, I am able to continue for a while (of course I do loose precise position).
Regards,
On my router table, I am using DMM system. I am 99% sure issue is with my environment and not DMM but in past I am able to get good information on this thread and hoping that somebody may have seen similar issue reported and can point me in the right direction.
I am attaching the g code file causing the issue. Very simple file created by Aspire. System execute line N26650 and stop at line N26660 (N26660G00X1.2901Y2.2109).
Attachment 171562
I tried five time and system always stop at this point. I started at different starting points on the table, did ref all and check dro and machine coordinates and my soft limits, nothing seems to be out of order. I do have licensed copy of Mach3 and also checked the line count to make sure that I am not stopping at eval line limit on mach3. Once I get stuck on G code, I am not able to physically jog, DRO do change but I am not able to move the spindle from stuck position. Only way to get out of this situation is to power cycle DMM drivers. And one thing more, although I was away from router table for few weeks to setup the mill, but I am able to make few carving gifts for friends last week .... so machine is in good working condition.
Once system do get stuck and I power cycle DMM drivers, I am able to continue for a while (of course I do loose precise position).
Regards,