We´re installing an older Wire cutter. But we are having truble sending the cnc programs to it, we´re using cimco to send the program, but we´re not having any luck.
only thing we´re certain of is that we have set 311, so that the baud rate should be 2400,.
is anyone in here, able to help us setup, the others, start stop bits and so ?`
I really hope someone will be able to help.
Thanks in advance.
Regards
Peter
only thing we´re certain of is that we have set 311, so that the baud rate should be 2400,.
is anyone in here, able to help us setup, the others, start stop bits and so ?`
I really hope someone will be able to help.
Thanks in advance.
Regards
Peter