Hello all!
I am looking to build a CNC plasma cutter, and am currently weighing options for controllers. My goal is to make it as cheap as I can without sacrificing too much quality. The two options I have narrowed it down to are the G540 and the Triple Beast. The 'simple' specs seem to be roughly the same (I doubt I am going to need the higher supported amperage of the TB though I may be wrong). I also would only need the 4th axis if I have a slave drive motor for the gantry (advice on this is also appreciated).
What other things should I consider? Any help/advise is appreciated.
Thanks, Istvan.
I am looking to build a CNC plasma cutter, and am currently weighing options for controllers. My goal is to make it as cheap as I can without sacrificing too much quality. The two options I have narrowed it down to are the G540 and the Triple Beast. The 'simple' specs seem to be roughly the same (I doubt I am going to need the higher supported amperage of the TB though I may be wrong). I also would only need the 4th axis if I have a slave drive motor for the gantry (advice on this is also appreciated).
What other things should I consider? Any help/advise is appreciated.
Thanks, Istvan.