Ridgid Tapping on Okuma MB-56VA

HI all, My mahcine is Okuma MB-56VA OSP-100M
now Been using it for over 5 years and its all good.
however when it comes to ridgid tapping I want to Peck ridgid tapping
the mahcine will peck
if I write this:

G83 X0 y0 R2. Z-30. (this will ridgid tap all the way down non stop)
however if I want to ridgid peck tap to z-30
then i have to put

G83 x0 Y0 R2.0 Z-10.
G83 Z-20
G83 Z-30
this will peck to z-30 no problems..
so My Question is I dont want to write G83 everytime infront of Z
so i want it to look like this:

G83 x0 Y0 R2.0 Z-10
Z-20.
Z-30.
is there a parrameter that can control the Z movment to peck like this?
bassically if i run it without the G83 infront of the Z- then it will ignore the numbers and only go to z-10. which is the only the first line..
anyone know whats the paramerts for the ridgid tapping cycles?

thanks