Hello everyone! I need 5 small citrus 3 prong pitch forks made.
See picture below.
It must be all stainless, 3 prongs, very little runout @ 1000 RPM, and can be completed and shipped in 2 week time frame.
I was thinking of using stainless steel jig dowels. One piece as the main shaft that will go into 3 jaw jacobs chuck. This piece can be .250 rod, and 4". The second piece will be a small circle cut from .250 plate, and roughly 3/4" wide. It will have 3 holes equally spaced. Inserted into these 3 holes will be another 3 pieces of stainless rod sharpened on one end. They can be tig welded from the rear of the small circle.
These are just ideas, and i can supply all the cad files, or drawings you need. If you are interested and think you can do this in a timely matter please PM me with your email and lets talk.
see pictures below. main Shaft will NOT be threaded as pictured.
Thanks,
Diyengineer
(PS the dimensions are subject to change a bit, but probably not much. In the design stage currently).
See picture below.
It must be all stainless, 3 prongs, very little runout @ 1000 RPM, and can be completed and shipped in 2 week time frame.
I was thinking of using stainless steel jig dowels. One piece as the main shaft that will go into 3 jaw jacobs chuck. This piece can be .250 rod, and 4". The second piece will be a small circle cut from .250 plate, and roughly 3/4" wide. It will have 3 holes equally spaced. Inserted into these 3 holes will be another 3 pieces of stainless rod sharpened on one end. They can be tig welded from the rear of the small circle.
These are just ideas, and i can supply all the cad files, or drawings you need. If you are interested and think you can do this in a timely matter please PM me with your email and lets talk.
see pictures below. main Shaft will NOT be threaded as pictured.
Thanks,
Diyengineer
(PS the dimensions are subject to change a bit, but probably not much. In the design stage currently).