Hello,
When I try to change tool (M6 T2)or spin the spindle (M3 S500) I get "ALARM 39-97 Spindle Drive not ready".
I new to this control, Do I have to enable something in the control?
VFS5 Spindle drive leds are:
ACTIVE: OFF
SYS OK: on
CPU: on
FAULT: on
Any advice will be helpful.
Thank you.
alarm 39-97.jpg
When I try to change tool (M6 T2)or spin the spindle (M3 S500) I get "ALARM 39-97 Spindle Drive not ready".
I new to this control, Do I have to enable something in the control?
VFS5 Spindle drive leds are:
ACTIVE: OFF
SYS OK: on
CPU: on
FAULT: on
Any advice will be helpful.
Thank you.
alarm 39-97.jpg