My CNC control system is dynapath delta 40M , i am a newer for CNC. When the machine is powered on, CRT display "CMOS battery low CMOS display mismatch type、Press F1 to RUN SETUP".
1.jpg
The older battery is LI-Battery with 3.6V , I measured the battery's voltage about 3.674V , it still supply enough enough for SRAM.What is wrong with my CNC? Do somone tell me what happened ?
2.jpg
I have no way to solve this problem,so i change the older battery with new on with 4V battery. but the problem still take on for the next day.
what can i DO?
1.jpg
The older battery is LI-Battery with 3.6V , I measured the battery's voltage about 3.674V , it still supply enough enough for SRAM.What is wrong with my CNC? Do somone tell me what happened ?
2.jpg
I have no way to solve this problem,so i change the older battery with new on with 4V battery. but the problem still take on for the next day.
what can i DO?