Hi all,
Still prowl the site everyday, but down two new versions there are very few times I can assist others with help right now.
However, I now have a problem that I need help with. I am still running v23 and just installed on a new computer. It is a windows 7 computer and all works fine except for one thing, as follows:
When I draw my cad, the machine default is a Mori. If I change it to my Haas, then when posting code, it gives me this error message:
C:\Program Files\BobCAD-CAM V23\NC\Mill\BobCAD1.clf NOT FOUND!
If I switch it back to Mori, it will post the code correctly using the Haas post processor. But, then when I go into Predator to run and simulate, the simulation will stop and freeze at any peck drill cycle, like G73 or G83, which must mean that the Mori does not use that exact format maybe. A G81 will work and that has been my work around for getting to finish the simulations, as I just manually change the code then change it back again. The problem is if I don't and it locks up at the G83, I have to go into Task Manager and end the program, as it freezes Predator up totally. Many times it causes other problems with the computer, leading to a complete restart.
Does anyone know why I would get that error message? I checked and could not manually find that file or any other .clf files on the computer. But switching the machine to Mori lets it post code.
I checked the machine files and I have all the machine from Acralock or something to Yasnak, Haas included.
Any help would be much appreciated.
Cheers---Mike
Still prowl the site everyday, but down two new versions there are very few times I can assist others with help right now.
However, I now have a problem that I need help with. I am still running v23 and just installed on a new computer. It is a windows 7 computer and all works fine except for one thing, as follows:
When I draw my cad, the machine default is a Mori. If I change it to my Haas, then when posting code, it gives me this error message:
C:\Program Files\BobCAD-CAM V23\NC\Mill\BobCAD1.clf NOT FOUND!
If I switch it back to Mori, it will post the code correctly using the Haas post processor. But, then when I go into Predator to run and simulate, the simulation will stop and freeze at any peck drill cycle, like G73 or G83, which must mean that the Mori does not use that exact format maybe. A G81 will work and that has been my work around for getting to finish the simulations, as I just manually change the code then change it back again. The problem is if I don't and it locks up at the G83, I have to go into Task Manager and end the program, as it freezes Predator up totally. Many times it causes other problems with the computer, leading to a complete restart.
Does anyone know why I would get that error message? I checked and could not manually find that file or any other .clf files on the computer. But switching the machine to Mori lets it post code.
I checked the machine files and I have all the machine from Acralock or something to Yasnak, Haas included.
Any help would be much appreciated.
Cheers---Mike