I'm using Bobcad V25 to design geometric designs for cutting on hardwood.
Ran the job on a piece of plywood to test it. It appears that the lines that
spoke out from the center of the arc extend just a hair too far past the
arc itself. (see atch)
I used quick trim to trim back the original line so as to fit between the
arcs. You can see from the 2nd image(see atch) that the tool cut just slightly
too far past the arc.
Was quick trim the wrong function to use? Any ideas on how to correct
the problem.
Thanks!
Jim
Ran the job on a piece of plywood to test it. It appears that the lines that
spoke out from the center of the arc extend just a hair too far past the
arc itself. (see atch)
I used quick trim to trim back the original line so as to fit between the
arcs. You can see from the 2nd image(see atch) that the tool cut just slightly
too far past the arc.
Was quick trim the wrong function to use? Any ideas on how to correct
the problem.
Thanks!
Jim