Is it possible to run any miter gears up close to 30k rpm? This would be driven by a porter cable router, so around 2hp.
Any advice is welcome, I would hate to spend a bunch of time just to have gears detonate on me. I am not finding much info in this area!
Could plastic gears handle the hp?
If no gear could stand up to it, do you have any other suggestions for transmitting power at 90degrees?
Joe
Any advice is welcome, I would hate to spend a bunch of time just to have gears detonate on me. I am not finding much info in this area!
Could plastic gears handle the hp?
If no gear could stand up to it, do you have any other suggestions for transmitting power at 90degrees?
Joe