Hey guys,
The G0704 came with this little tool with a pin on the end of it that's used for holding the spindle in place when tightening the top nut. This tool will most likely break after a few uses (Mine is dead in the water after 4 uses). This might mean I'm tightening the spindle nut too much, or maybe it means that tool is just crap.
Either way, it looks like I'm going to need another one. What is this tool called? Is there a better alternative to this thing? There has to be...
If there is, I don't know what it's called, so I cannot find one to purchase it. Or, I suppose I could make one of my own. Anyone have any experience with this? What solutions did you come up with?
The G0704 came with this little tool with a pin on the end of it that's used for holding the spindle in place when tightening the top nut. This tool will most likely break after a few uses (Mine is dead in the water after 4 uses). This might mean I'm tightening the spindle nut too much, or maybe it means that tool is just crap.
Either way, it looks like I'm going to need another one. What is this tool called? Is there a better alternative to this thing? There has to be...
If there is, I don't know what it's called, so I cannot find one to purchase it. Or, I suppose I could make one of my own. Anyone have any experience with this? What solutions did you come up with?