Problem V24 How to "force tool change"?

If you take a look at the file I've attached you'll see that I want to profile the outside of the part. Since the part cannot be held in a vise it will be clamped to the table. I need to profile two sides, move the clamps, then profile the other two sides. I think for this part I'll just post the operations separately but for future reference I'm wondering if there's a way in the software to command a tool change and an M00 so it will return the tool to tool change position and wait until I hit go to cut the other two sides.

Thanks.

Ben

Attached Files

• forum test part.zip‎ (477.3 KB)