Hello.
I'm doing a mold, and a 1" shaft need to fit in it (see highlighted area from screen shot). Not only am I using a surfacing operation (with 1/2 ball mill), but I also have to use a contouring operation (see OP#7&8) to clean the "top edge" or the 1" shaft will not fit.
My question is, is this standard practice, or am I doing something wrong?.
glovebox20
I'm doing a mold, and a 1" shaft need to fit in it (see highlighted area from screen shot). Not only am I using a surfacing operation (with 1/2 ball mill), but I also have to use a contouring operation (see OP#7&8) to clean the "top edge" or the 1" shaft will not fit.
My question is, is this standard practice, or am I doing something wrong?.
glovebox20